Probe Initial Adjust
sets the power correction that the access terminal applies to the open loop power estimate to adjust its initial transmission on the Access Channel (when transmitting the initial access probe in an access probe sequence).
When the test set is in the Active Cell operating mode,
Probe Initial Adjust
is sent in the Access Parameters message (see
TAP/ETAP Data Connection Call Flow
). It can be changed at any time and will be sent out in the next Access Parameters message.
When the test set is in the
IS-856 Test Operating Mode
,
Probe Initial Adjust
is set to the value that is expected to be used by the access terminal.
GPIB Command: CALL[:CELL]:APARameter:PROBe:IADJust
Manual Operation: How Do I Change Access Parameters?