N109x Trigger Tab

Instrument
DCA-X
N109X
Flex Apps:
FlexDCA

N109X-Series Trigger

The N109X-series Trigger tab is displayed whenever a communication link is established with an N109x-series DCA-M sampling oscilloscope extended module. If multiple N109x-series oscilloscopes are connected, one dialog box tab will be displayed for each N109x-series oscilloscope.

The content of this tab is for information only. There are no settings. An N109x-series DCA-M requires that its Trigger Source be set to Front Panel or Free Run. This is done in the dialog box's General Trigger Setup tab. The normal setting is Front Panel which is shown on the N109x Trigger tab as Clock In. The Free Run setting can be used to visually confirm that an input signal is present if you are having trouble viewing a signal. The available filter rates are listed on the N109x's front panel. These filter rates are provided as options. If you need to change the filter rate options, you must return the DCA-M to Keysight.

Trigger Source
Setting in
General Trigger Setup Tab
Source Shown in
N1090A Trigger Tab
Free Run Free Run
Front Panel Clock In
CDR (86108B module installed) Clock In
PTB (86108B module installed) Clock In

Although all connected N109x-series oscilloscopes and an N1000A or 86100D (if present) have independent triggers, the Trigger Source setting applies to all of these devices. Pattern Lock, also set the dialog box's General Trigger Setup tab can be selected for N109x-series oscilloscope if the pattern lock option is installed.