How Do I Change Access Parameters?

Last updated: January 3, 2008

General Procedure

A. Select the Access Parameters Menu.

Press the CALL SETUP key.
Press the left More key, go toCall Control 2 of 2 (in the Test Application) orCall Control 2 of 3 (in the Lab Application).
SelectAccess Network Info ( F2 ), go to AN Info menu.
All access parameters are available by pressing the F4 on AN Info menu. Depending upon the current setting of the Access Channel MAC Subtype, the F4 is labeled as either Access Parameters or Enhanced Access Parameters .
- When the test set is configured to Default Access Channel MAC Subtype (see To Configure the Test Set to Default Access Channel MAC Subtype for detailed procedure), the F4 is labeled as Access Parameters .
- When the test set is configured to Enhanced Access Channel MAC Subtype (see To Configure the Test Set to Enhanced Access Channel MAC Subtype for detailed procedure), the F4 is labeled as Enhanced Access Parameters .
Select F4 . A typical display for the Access Parameters menu or the Enhanced Access Parameters menu is shown as below.

B. Set an Access Parameter.

Turn the knob to highlight a parameter and then press the knob.
Enter a value or selection and press the knob.
Select Close Menu ( F6 ).

To Configure the Test Set to Default Access Channel MAC Subtype

To configure the test set to Default Access Channel MAC Subtype,

set the Protocol Rel ( F11 on Call Parms 2 of 3) to 0 (1xEV-DO) , or
set the Protocol Rel ( F11 on Call Parms 2 of 3) to A (1xEV-DO-A) and set the Release A Physical Layer Subtype to Subtype 0 from the Protocol Subtype Configuration menu by pressing the F12 (Protocol Subtype Config ).
set the Protocol Rel ( F11 ) toA (1xEV-DO-A) , set theRelease A Physical Layer Subtype to Subtype 2 and PL Subtype 2 Access Channel MAC Subtype to Default from the Protocol Subtype Configuration menu by pressing the F12 (Protocol Subtype Config ).

To Configure the Test Set to Enhanced Access Channel MAC Subtype

To configure the test set to Enhanced Access Channel MAC Subtype, set the Protocol Rel ( F11 ) toA (1xEV-DO-A) , set theRelease A Physical Layer Subtype to Subtype 2 and PL Subtype 2 Access Channel MAC Subtype to Enhanced from the Protocol Subtype Configuration menu by pressing the F12 (Protocol Subtype Config ).