Input Signal Requirements

Last updated: May 24, 2006

All measurements meet or exceed specifications when the following requirements are met:

• The frequency of the signal being measured must be in the range of 412 MHz to 483 MHz, 800 MHz to 960 MHz, or 1.7 GHz to 2.0 GHz, and within 100 kHz of the expected frequency.
• The signal level into the test set's RF IN/OUT connector must be within 9 dB of the expected input power (see Expected Power ), and must be:

Input Signal Power Level Requirements

Measurement	Input Signal Power Level Requirement
Access Probe Power	between -45 dBm and +37 dBm (-45 is the minimum level required to trigger the access probe power measurement).
Channel Power	between -61 dBm and +37 dBm (with reliable but unspecified performance down to -69 dBm).
Digital Average Power	between -30 dBm and +37 dBm.
Packet Error Rate	between -25 dBm and +37 dBm.
TX Dynamic Power	between -61 dBm and +37 dBm (with reliable but unspecified performance down to -69 dBm).
TX Spurious Emissions	between 0 dBm and +30 dBm.
TROLPC	between -25 dBm and +37 dBm.
Waveform Quality + Code Domain	between -25 dBm and +37 dBm.